Search Catalog
      GO   
 All Categories    Model 24
View Cart View RFQs
 Shopping Cart 0 Items
 Request for Quote 0 Items
All Categories > Machinery > Lapping / Polishing Machinery > Floor Standing Single Sided Machinery > Model 24 > Item # LMPL-24  
Add To Cart Request Quote

Item # LMPL-24, Pneumatic Lift Flat

    border="0" Printable Page  
    Email Email This Page  
    Save To Favorites Save To Favorites
  

  • The pneumatic lift version of the Model 24 is based on the open face machine, but has the pressure weights attached to the rods of three pneumatic cylinders. Selfaligning bearings accommodate any slight vertical misalignment and ensure an even pressure is applied to components inside the conditioning ring.
  • The cylinders are mounted vertically on sliding rails within a fabricated hollow, known as a “spider bar”. This is cantilevered over the lap plate and is mounted onto an upright column bolted to the machine frame. The primary function of the pneumatic arrangement is to permit loading and unloading to be carried out without the need to lift pressure weights manually. However, they can be used to supply additional loading to the components within the conditioning ring should this be required.
  • Operator safety is a primary concern in the design. Movement of each pressure weight up or down is controlled by a two hand anti-tie down control box. This arrangement requires the use of both hands on two separate buttons to operate, and ensures that the operator cannot injure his hands or arms when lowering the weights.
  • A further safety feature is that thepressure weights are mechanically latched when in the fully raised position so that, should the compressed air supply or electrical power fail, they will not fall.
  • The machine is intended for use with free abrasive slurries -abrasive grit suspended in an oil-based or water based vehicle.
  • Flatness of the lap plate, and consequently of the work, is controlled by adjusting the position of the three conditioning rings relative to the lap plate track.
  • The pneumatic cylinders and pressure weights are also capable of the corresponding adjustment.
  • This machine is also available in Open Face version.




 Specifications   Standard Features   Standard Tooling   Available Options   

Model Type
24

No. of Conditioning Rings
3

Range of Load for Pressure
1.5 to 85 kg

Range of Load for Pressure
331 to 1871 lbs

Drive Motor
1.5 kW

Drive Motor
2 HP

Standard Lap Plate Speed
70 rpm

Lap Speed (with Variable Speed Drive)
0 - 70 rpm

Lapping Plate O.D.
24 inches

Lapping Plate O.D.
610 mm

Lapping Plate I.D.
4.5 inches

Lapping Plate I.D.
114 mm

Conditioning Ring O.D.
11.25 inches

Conditioning Ring O.D.
268 mm

Conditioning Ring I.D.
9.75 inches

Conditioning Ring I.D.
248 mm

Wear Life
1.4 inches

Wear Life
35 mm

Weight
700 kg

Weight
1544 lbs

Dimensions
68 x 63 x 80 inches

Dimensions
1730 x 1610 x 2020 mm

Gross Weight
997 kg

Gross Weight
2198 lbs

Power Supply
230 V/460 V, 3 phase, 60 Hz


Add To Cart Request Quote