Search Catalog
      GO   
 All Categories    Model 36
View Cart View RFQs
 Shopping Cart 0 Items
 Request for Quote 0 Items
All Categories > Machinery > Lapping / Polishing Machinery > Floor Standing Single Sided Machinery > Item # LMPL-36  
Add To Cart Request Quote

Item # LMPL-36, Model 36

    border="0" Printable Page  
    Email Email This Page  
    Save To Favorites Save To Favorites
  

  • The pneumatic lift version of the Lapmaster Model 36 is based on the Open Face design, but the pressure weights are attached, through selfaligning bearings, to the rods of three pneumatic cylinders. These are mounted vertically on sliding rails within a fabricated hollow assembly, known as a “spider bar”. This fabrication is cantilevered over the lap plate and is mounted onto a tubular upright column bolted to the machine frame. The free end is restrained by a tie rod to prevent excessive bending stress when high lapping pressures are used.
  • The primary function of the pneumatic arrangement is to permit loading and unloading to be carried out without the need to lift pressure weights manually. However they can be used to supply additional loading to the components within the conditioning ring should this be required.
  • Operator safety is a primar y concern in the design. Movement of each pressure weight up or down is controlled by a two hand anti-tie down control system. This arrangement requires the use of both hands on two separate buttons to function and ensures that the operator cannot injure his hands or arms when lowering the weights.
  • A further safety feature is that the pressure weights are mechanically latched when in the fully raised position so that, should the compressed air supply or electrical power fail, they will not fall.
  • The machine is intended for use with free abrasive slurries - abrasive grit suspended in an oil-based or water based vehicle. A diamond slurry dispensing system can also be fitted if required.
  • Flatness of the lap plate, and consequently of the work, is controlled by adjusting the position of the three conditioning rings relative to the lap plate track. The pneumatic cylinders and pressure weights are also capable of the corresponding adjustment.
  • This machine is also available in Open Face version.




 Specifications   Standard Features   Standard Tooling   Available Options   

Model Type
36

No. of Conditioning Rings
3

Drive Motor
4 kW

Drive Motor
5 HP

Standard Lap Plate Speed
58 rpm

Lapping Plate O.D.
36 inches

Lapping Plate O.D.
914 mm

Lapping Plate I.D.
6.75 inches

Lapping Plate I.D.
172 mm

Conditioning Ring O.D.
419 mm

Conditioning Ring O.D.
16.5 inches

Conditioning Ring I.D.
368 mm

Conditioning Ring I.D.
14.5 inches

Wear Life
2.8 inches

Wear Life
70 mm

Weight
1202 kg

Weight
2650 lbs

Shipping Weight
1383 kg

Shipping Weight
3050 lbs

Power Supply
230 V/460 V, 3 phase, 60 Hz


 MORE IMAGES 

·  Dimensional Drawing


Add To Cart Request Quote